Power Up
The Crown only has one power button. If the Crown has a very low battery, you'll need to plug in the charger. To turn Crown on, press and hold the power button for two (2) seconds.
The Crown will take a few minutes to power up. When the Crown has finished starting the OS, the LED will begin pulsing yellow if it's charging or green if it's fully charged.
If your device is unplugged and ready to go, the status LED is solid white.
When the Crown is low on battery and you plug in the charger, the Crown will automatically begin to begin charging, if the Crown battery was dead, it may need a few minutes on the charger before safely turning on.
If the LED flashes, such as once per second, unplug, replug the charger, and immediately hold the power button for six seconds. A more powerful charger like a MacBook charger can take the Crown out of this state.
Powering Off
Press and hold the power button for two seconds for a safe shutdown.
The status LED will turn red for about 60 seconds.
If the LEDs stay on for over a minute, you can perform a hard shutdown by holding the power button for six seconds.
Safe shutdowns are recommended instead of hard shutdowns.
Charging
If you wish to charge your Crown, please use the charger included. You can view your Crown's battery percentage on the Neurosity App or the Console. While charging, the Crown may not be worn or used.
The Crown's status LED will show a pulsing yellow light while charging.
When the Crown is fully charged, the status LED will turn solid green.
Comments
3 comments
These images are old. This article should be updated to include images for all three of your products. The crown doesn't power up like this.
how long does it take to charge the crown, been 12 hours and still showing red battery light, maybe I received a defective unit
got it, battery needs to be at 98% to show green LED
Please sign in to leave a comment.